Ground To Top Of Hood | 3.33m
|
B-Pin Height - Maximum Lift | 5.49m
|
Reach - Maximum Lift | 2.08m
|
Wheel Base | 4.55m
|
Ground To Top Of Rops | 4.18m
|
Ground To Center Of Axles | 0.98m
|
Maximum Overall Length | 12.2m
|
Полезная мощность | 403.5kw
|
Rated Speed | 1700rpm
|
Torque Rise | 58%
|
Bore | 144.8mm
|
Stroke | 182.9mm
|
Gross Power - Iso 14396 | 432.6kw
|
Peak Power Speed | 1,500 rpm
|
Peak Torque @ (Speed) - Sae J1995 | 2852.7Nm
|
Forward 1 (Virtual) | 7 км/ч
|
Forward 2 (Virtual) | 11.3 км/ч
|
Forward 3 (Virtual) | 22.3 км/ч
|
Forward 4 (Virtual) | 32.2 км/ч
|
Reverse 1 (Virtual) | 7 км/ч
|
Reverse 2 (Virtual) | 11.3 км/ч
|
Reverse 3 (Virtual) | 28.2 км/ч
|
Bucket Capacities | 4.7-13 m3 (6.2-17 yd3)
|
Oscillation Angle | 13 °
|
Bucket Capacity Range | 4.7-13 m3 (6.2-17 yd3)
|
Diesel Exhaust Fluid Tank | 33L
|
Note | All non-road Tier 4 Final/Stage IV diesel engines are required to use: The machine has the flexibility to run on either ultra-low-sulfur diesel fuel (ULSD with 15 ppm of sulfur or less) or up to B20
|
Cooling System - Jacket Water | 113.6L
|
Cooling Systems - Power Train | 30.3L
|
Raise | 8 s
|
Dump | 2.2 s
|
Lower Float Down | 3.5 s
|
Rack Back | 4.5 s
|
Lift/Tilt System - Circuit | EH-Positive Flow Control, Flow Sharing
|
Lift/Tilt System - Pump | Variable Displacement Piston
|
Tilt Cylinder - Stroke | 685.8mm
|
Lift Cylinder - Bore | 221mm
|
Lift Cylinder - Stroke | 1049.1mm
|
Tilt Cylinder - Bore | 221mm
|
Steering System - Circuit | Pilot, Load Sensing
|
Steering System - Pump | Piston, Variable Displacement
|
Steering Cut Off Pressure | 4351 psi
|
Steering Cycle Times - Low Idle | 5.6 s
|
Steering | ISO 5010:2007
|
Air Conditioning | The air conditioning system on this machine contains the fluorinated greenhouse gas refrigerant R134a (Global Warming Potential = 1430). The system contains 1.8 kg of refrigerant which has a CO2 equi
|
Rops/Fops | ROPS/FOPS meet ISO 3471:2008 and ISO 3449:2005 Level II standards
|
Operator Sound Level - Iso 6396 | 72 dB(A)
|
Machine Sound Level (Iso 6395) | 109 dB(A)
|
Note (1) | The operator sound pressure level was measured according to the test procedures and conditions specified in ISO 6396:2008. The measurement was conducted at 70 percent of the maximum engine cooling fa
|
Note (2) | Hearing protection may be needed when the machine is operated with a cab that is not properly maintained or when the doors or windows are open for extended periods or in a noisy environment.
|
Note (3) | The machine sound power level was measured according to the test procedures and conditions specified in ISO 6395:2008. The measurement was conducted at 70 percent of the maximum engine cooling fan sp
|
---|